TPi Arcade Inc. Company Profile
Our 117,000 total square-foot, computer controlled facilities house state-of-the-art computer controlled equipment run by our manufacturing experts. Compared with a typical sand foundry, we produce finer finishes and cast to tighter and more consistent tolerances. The result? An upgrade in quality at a comparable or even lower total cost.
For more information contact TPi Arcade Inc.
V-Process Aluminum Decreases Machining for Mustang Manifold from 150 to 90 Minutes
By using V-Process aluminum casting on the air intake manifold of the new Stage 3 Mustang, Roush Performance Products reduced machining time for the part from 150 to 90 minutes. The recently released Stage 3 Mustang, a high-performance version of Ford's Mustang GT, includes a custom air intake manifold. When Roush tried traditional aluminum casting for the manifold, they found that the parts lacked dimensional stability, increasing machining time and adding to the cost. Manifolds produced by TPI Arcade, Inc., Arcade , New York, using V-Process technology are so accurate that one machining setup works for all parts, reducing machining time by almost half and ultimately reducing the cost of the part. In addition, the smooth finish of the V-Process produces an attractive surface. "The parts produced by TPI Arcade Inc. are so consistent that the machinists just set them up and let them run," says Mark Yagelo, design engineer at Roush Performance Products.
TPi Arcade Inc.
E: [email protected]
7888 Rte. 98